Indicator Lamp; Side Handle - Makita HR4003C Instruction Manual

Indicator lamp

1
2
1.
indicator lamp (red)
The green power-ON indicator lamp lights up when the
tool is plugged in. If the indicator lamp does not light up,
the mains cord or the controller may be defective.
start even the tool is switched on, the carbon brushes
may be worn out, or the controller, the motor or the ON/
OFF switch may be defective.
If above symptoms occur, stop using the tool immedi-
ately and ask your local service center.
The red service indicator lamp lights up when the car-
bon brushes are nearly worn out to indicate that the tool
needs servicing. After some period of use, the motor
automatically shuts off.
ASSEMBLY
CAUTION:
unplugged before carrying out any work on the
tool.

Side handle

CAUTION:
or demolishing. Do not use it when drilling in
concrete, masonry, etc. The tool cannot be held
properly with this side handle when drilling.
The side handle can be swung 360° on the vertical and secured at
2. Service
any desired position. It also secures at eight different positions back
and forth on the horizontal. Just loosen the clamp nut to swing the
side handle to a desired position. Then tighten the clamp nut securely.
Side grip
The side grip swings around to either side, allowing
easy handling of the tool in any position. Loosen the
side grip by turning it counterclockwise, swing it to the
desired position and then tighten it by turning clockwise.
Installing or removing the bit
7 ENGLISH
1
2
1. Side handle 2. Clamp nut
CAUTION:
safety when drilling in concrete, masonry, etc.
1
1. Side grip
2
1
1. Bit shank 2. Bit grease