CHAPTER 6: ACTUAL VALUES
The following metered values are available for the broken rotor bar detection feature.
— This value indicates the level of the broken rotor bar spectral component relative to the spectral
COMPONENT LEVEL
component of the system frequency.
— Indicates the frequency of the broken rotor bar spectral component.
COMPONENT FREQ
— Indicates the average motor load at the time of the broken rotor bar data acquisition stage.
MOTOR LOAD AT BRB CALC.
— Indicates the motor load standard deviation at the time of the broken rotor bar data acquisition
LOAD DEV.AT BRB CALC.
stage.
— Indicates the time stamp of the broken rotor bar calculation.
TIME OF BRB CALC.
— Indicates the learned maximum level of the broken rotor bar spectral component since the
MAXIMUM COMPONENT LEVEL
last data clear.
— Indicates the frequency of the learned maximum broken rotor bar spectral component.
MAXIMUM COMPONENT FREQ.
— Indicates the average motor load at the time when data for the maximum broken rotor bar was
MOTOR LOAD AT BRB MAX
acquired.
— Indicates the motor load standard deviation at the time when data for the maximum broken rotor
LOAD DEV. AT BRB MAX
bar was acquired.
— Indicates the time stamp of the maximum broken rotor bar component level.
TIME OF MAXIMUM BRB
6.4.7 Tracking frequency
ACTUAL VALUES METERING TRACKING FREQUENCY
TRACKING FREQUENCY
The tracking frequency displays here. The frequency is tracked based on the selection of the reference source with the
FREQUENCY AND PHASE REFERENCE
System section of chapter 5 for details.
6.4.8 FlexElements
ACTUAL VALUES METERING FLEXELEMENTS FLEXELEMENT 1(16)
FLEXELEMENT 1
The operating signals for the FlexElements are displayed in pu values using the following definitions of the base units.
M60 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
LOAD DEV.AT BRB
CALC.: 0.01 x FLA
TIME OF BRB CALC.:
2009/03/05 10:22:39
MAXIMUM COMPONENT
LEVEL: -58.3 dB
MAXIMUM COMPONENT
FREQ.: 62.05 Hz
MOTOR LOAD AT BRB
MAX: 0.95 x FLA
LOAD DEV. AT BRB
MAX: 0.02 x FLA
TIME OF MAXIMUM BRB:
2009/03/04 11:32:18
TRACKING FREQUENCY:
60.00 Hz
setting in the
SETTINGS SYSTEM SETUP POWER SYSTEM
FLEXELEMENT 1
OpSig:
0.000
METERING
menu. See the Power
6-21
6