Makita TM3010C Instruction Manual page 6

NOTE:
from 5 to 1. Forcing the dial may damage the
tool. When changing the dial direction, always
turn the dial moving it through each intermediate
number.
Constant speed control
Electronic speed control for obtaining constant speed.
rate is kept constant even under load condition.
ASSEMBLY
CAUTION:
unplugged before carrying out any work on the
tool.
tool (optional accessory)
WARNING:
Installing application tool upside down may
damage the tool and cause serious personal
according to your work. Application tool can be
installed at an angle of every 30 degree.
CAUTION:
moving part of the lock lever from time to time.
Otherwise dust may accumulate in the moving
part of the lock lever and hinder its smooth
movement.
tool may be damaged.
2
1. Holder bolt 2. Lock lever
1. Open the lock lever fully. And remove the holder
bolt.
1. Holder bolt 2. Holes in the application tool
3.
2. Put an application tool (optional accessory) on the
3. Insert the holder bolt till it stops. And then, return
the lock lever to its original position.
When using sanding application tool, mount the appli-
cation tool on the sanding pad so that it matches the
sanding pad direction.
paper.
As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
To remove the holder bolt, follow the installation proce-
dures in reverse.
1
6 ENGLISH
3
2
1
-