I/O Circuit Diagrams And Output Waveform - Panasonic SF4B-H12C Instruction Manual

2-5-2 I/O Circuit Diagrams and Output Waveform

<In case of using I/O circuit for PNP output with SF4B-□C>
Emitter
0.22μF
0.22μF
Internal circuit
Receiver
0.22μF
Internal circuit
*S1
Switch S1
● Emission halt input / Reset input
For manual reset ... Vs to Vs - 2.5V (sink current 5mA or less) : Emission halt (Note), Open: Emission
For auto-reset ... Vs to Vs - 2.5V (sink current 5mA or less) : Emission (Note), Open: Emission halt
● Interlock setting input
Vs to Vs - 2.5V (sink current 5mA or less): Valid (Note), Open: Invalid
Note: Vs is the applying supply voltage.
<Reference>
● K1, K2: External device (Forced guided relay or magnetic contactor)
● For more information about wiring, refer to Section 2-5-4 and subsequent sections.
© Panasonic Industrial Devices SUNX Co., Ltd. 2014
Ramco National
(Brown) +V
(Pale purple) Interlock setting input
470Ω
(Pink) Emission halt input / Reset input
470Ω
(Yellow-green / Black) Auxiliary output
(Shield) Output polarity setting wire
(Blue) 0V
(Orange) Synchronization +
(Orange / Black) Synchronization -
Users' circuit
(Orange / Black) Synchronization -
(Orange) Synchronization +
(Brown) +V
(Yellow-green) External device monitor input
470Ω
(Black) Control output 1 (OSSD 1)
(White) Control output 2 (OSSD 2)
(Shield) Output polarity setting wire
(Blue) 0V
Users' circuit
800-280-6933 | nsales@ramcoi.com
Wiring
*S1
*S1
+
24V DC
±10%
-
Load
K1 K2
K1
K2
www.panasonicsensors.com
37