Philips HTS3106/F7 C Service Manual page 17

How to Verify the Firmware Version
1. Turn the power on.
2. Remove the disc on the tray and close the tray.
3. Press [ ] (skip up), [1], [2], and [3] buttons on the
remote control unit in this order.
Fig. e appears on the screen. All VFD lights.
Version Display
F/W Name : *******
Version : *.**.**
Region : *-*
Pickup : **
ESN : ********************************
DRM : OK
Default Setting : --
Default Setting : STOP
VFD/LED Check : OK
Fig. e
4. To exit this mode, press [
" * " differ depending on the models.
End : STANDBY-ON
] button.
When update is interrupted during
the Software Update
In a case where software update is interrupted due to
unplugging of AC cord, removal of SD card or power
outage, the unit will start from the software update
mode the next time it is turned on. (Unless the update
is completed, the unit starts from software update
mode and not from the Home Menu.)
Fig. f appears on the screen when software update is
interrupted.
The software update failed. For the state that the remote control key does not
work, press the [STANDBY/ON] key of this unit for 10 seconds. As this unit will
turn off, press the [STANDBY/ON] key again. After this unit turns back on, the
software update will start again.
If the software update failed with above procedure, please do the following.
1. Write the software downloaded on our website in SD Memory Card.
2. Press the [STANDBY/ON] key of this unit for 10 seconds.
3. As this unit will turn off, press the [STANDBY/ON] key.
Follow the procedures below to enter the software
update mode again.
1. Press the [STANDBY/ON] button of this unit for 10
seconds.
2. As this unit will turn off, press the [STANDBY/ON]
button again.
3. After this unit turns back on, the software update
will start again. Fig. g will appear.
Please wait for a few minutes. Do not unplug the AC cord or interrupt the
updating process. When update is completed unit will automatically turn off,
and unit will automatically turn back on.
Updating Software....
******* Ver *.**.**
Note:
If the software update fails following the above
procedure, please perform the following.
1. Write the software downloaded on our website in
SD Memory Card.
2. Insert the SD Memory Card into the SD card slot.
3. Press the [STANDBY/ON] button of this unit for 10
seconds.
4. As this unit will turn off, press the [STANDBY/ON]
button.
1-7-2
Software Update
Fig. f
Software Update
CHECK SUM : - - - -
" * " differ depending on the models.
Fig. g
HT3.5(P&F)_(VFD)FW