Firmware Renewal Mode - Philips HTS3106/F7 C Service Manual

Note: The file extension of the available firmware is "b41".
1. Turn the power on and remove the disc on the tray
and close the tray.
2. Press [ ] (skip up), [6], [5], and [4] buttons on the
remote control unit in this order.
Fig. a appears on the screen.
F/W Version Mode
Please select software update mode.
Disc
USB
SD Card
The available software update mode will
differ depending on the model type.
Fig. a Version Up Mode Screen (Example)
3. Select "Disc" or "USB" or "SD Card" and press
[OK] button on the remote control unit. The tray
will open automatically, if "Disc" is selected.
4. Insert the disc or USB Memory Stick or SD Card
for version up.
5. The BD player enters the F/W version up mode
automatically. Fig. b will appear on the screen.
Make sure to insert the proper F/W for the state of
this model.
F/W Version Mode
Loading Disc...
(*1)
Fig. b Programming Mode Screen (Example)
The appearance shown in (*1) of Fig. b is
described as follows:
No. Appearance
1 Loading Disc...
2 Reading...
Updating
3
Software...

FIRMWARE RENEWAL MODE

" * " differ depending on the models.
F/W Name : ******* Ver *.**.**
" * " differ depending on the models.
F/W Name : ******* Ver *.**.**
State
Loading the disc
Checking the new
firmware and preparing
the update system
Downloading and
writing the new firmware
6. After reading the new firmware, the power will turn
off automatically.
7. The power turns on and updating starts
automatically.
Fig. c will appear on the screen.
Please wait for a few minutes. Do not unplug the AC cord or interrupt the
updating process. When update is completed unit will automatically turn off,
and unit will automatically turn back on.
Updating Software....
******* Ver *.**.**
Fig. c Version Up Mode
8. After the update, Fig. d will appear on the VFD and
the power will turn off automatically.
Fig. d VFD upon Finishing the Programming Mode (Example)
9. The power turns back on automatically. If disc
mode was selected, the tray will open
automatically. Remove the disc or USB Memory
Stick or SD Card from the unit.
Notes:
• All the settings will be put back to factory-default.
• Do not unplug the AC cord and do not remove the
disc or USB Memory Stick or SD Card while this
procedure.
The following USB Memory Stick/SD Card can be
used for software update. Make sure to use a device
that has enough space.
• USB Memory Stick (FAT16/FAT32 file system)
• SD/Mini SD/Micro SD Card (FAT12/FAT16 file system)
• SDHC/Mini SDHC/Micro SDHC Card (FAT32 file system)
1-7-1
Software Update
CHECK SUM : - - - -
" * " differ depending on the models.
HT3.5(P&F)_(VFD)FW