Wiring Connection - Kenwood DDX795 Instruction Manual

Installation and Connection Installation and Connection

Wiring connection

For DDX795/DDX775BH/DDX6018BT/DMX6018BT/DDX5018BT/DDX595/DDX575BT
*1 *2
*1 *2
Purple with white stripe
Light green
10 A fuse
¥
]
White / White with black stripe
] [
Gray / Gray with black stripe
Green ] / Green with black stripe [
]
Purple / Purple with black stripe
Brown
Orange with white stripe
Light blue with yellow stripe
Blue with white stripe (12 V 350 mA)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
«
*2
STEERING
REMOTE
[
USB input terminal (1 m)
To the car's reverse lamp harness when using the optional rear view camera
REVERSE
PRK SW
[
To front speakers (left)
To front speakers (right)
To rear speakers (left)
[
To rear speakers (right)
Not used.
MUTE
To the car light control switch
ILLUMI
STEERING WHEEL
REMOTE INPUT
To the OE remote adapter (not supplied) which is compatible with your car
REMOTE CONT
To the power control terminal when using the optional power amplifier (Or)
ANT.CONT
P.CONT
To the control terminal of the motor antenna or to the power terminal for the booster amplifier of film-type antenna
Gray/Red
Connect to your vehicle's
ST REMOTE
GND
steering remote harness.
Bright green/Red
Contact your KENWOOD
Input 1
dealer for details.
Purple/Red
Input 2
Connect the antenna cord to the antenna terminal.
Extension wire ( ø )
To the car's parking brake detection switch harness
(For best safety, be sure to connect the parking sensor.)
*1 Only for DDX795/DDX775BH/DDX595/DDX575BT.
*2 Only for DDX6018BT/DMX6018BT/DDX5018BT.
Ignition key switch
Car fuse
Car battery
To the car chassis
ENGLISH 63