Honeywell Acuix Quick Installation Manual page 2

2. (Optional) If you are installing the wall mount with a corner adapter
(HDXCMA1) or pole mount adapter (HDXPMA1) then:
Pole Adapter
• Secure the pole mounting bracket to the pole using hardware
specifically designed for the surface/material. There are four
cutouts (two on each side), 0.24" x 0.75" (6 mm x 19 mm), to
accommodate straps to secure the pole mounting bracket to a
pole. See Figure 4.
Corner Adapter
• Secure the corner bracket using hardware specifically designed
for the surface/material. The bracket has eight 0.39" (10.0 mm)
holes; four on each side. See Figure 5.
3. (Optional): If you are installing with a corner or pole adapter, line up the
hole pattern on the wall mount with the hole pattern on the corner or
pole adapters.
4. Secure the wall mount to the wall using hardware specifically designed
for the surface. There are four 0.28" (7.00 mm) diameter mounting
holes for securing the mount.
Figure 4 Pole Mount Adapter Dimensions (HDXPMA1)
55 degrees
6.1" (155 mm)
1" (25.4 mm)
diameter
4.6" (116.8 mm)
4 cutouts (2 on each side)
ACUIX Stick Mount Quick Installation Guide
Figure 5 Corner Adapter Dimensions (HDXCMA1)
3.94" (100 mm)
1" (25.4 mm) diameter
4.6" (116.8 mm)
2b
Installing a Ceiling Mount
The ceiling mount is installed directly to a horizontal load-bearing surface
and supports up to 25 pounds (11.7 kg).
1. Route field wiring as required into the wiring access hole and through
the center of the ceiling mount.
Approximately one foot (0.3 m) of cable must extend past the mount.
2. Secure the ceiling mount to the ceiling using hardware specifically
designed for the surface.
There are four 0.47" (12.00 mm) diameter mounting holes for securing
the mount. See Figure 6.
90 degrees
3.54" (90 mm)
6.3" (160 mm)
0.39" (10 mm) diameter (x8 through)
2