1. IN/ON LINE BOARD I/O PB-12
1-1. To mount the I/O pb-12 in the P/C unit
1)
To open upper case of the P/C unit (In case using SA-3000 as a P/C unit), release the
one screw of the back side and lift the upper cas up from the CPU unit.
2) Lift up the upper case.
2)
Mount the I/O PB-12 to the mother boards slot connector as shown in the following.
[Hardware Configuration]
1) Release the screw.
NOTE: There are 6 hooks at the
bottom side of upper case. Please
be careful.
UPS
Mother Board
CPU
RAM
R3 Printer cable
M/O Board
VGA BOARD
I/O PB-12
— 1 —
BATTERY 1
BATTERY 2
3.5 Inch FDD
HDD cable