Table of Contents
Advertisement
5-5-3. C_SETUP.EXE
Load C_DIAG and press Enter.
POS_check Exist();
POS = read ID(); = ca02 (If the ID is wrong, No more message and to be error end.)
POS_read Version();
board_chk();
*******************************************************************************************************
*
*******************************************************************************************************
*
NETWORK TEST ( C_NET CHIP )
*******************************************************************************************************
1:
NET START
2:
NET END
3:
SEND/RECV MODE (Connection)
4:
RECS/SEND MODE (Connection)
5:
SEND MODE
6:
RECV MODE
7:
SEND MODE
8:
RECV MODE
*******************************************************************************************************
21:
UPS STATUS
22:
UPS DC CUT
*******************************************************************************************************
ENTER DIAG Number
1)
Input the number and press Enter.
2)
Thereafter testing program, The display will be going back to menu screen as above.
3)
All testing program can quit by <ESC> key, then going back to menu screen.
Note:
1. Test program No. 7 and 8 are not allowed. (Only software testing)
2. In case of that test programming No. 3, 4, and 6 are not working as long as
No. 5 is working, The IRQ setting of C_NET may clash with the other software.
[Each test command programming]
1. NET START
To initialize the Network and Network controller.
You have to install this program first, before using program 3. ~ 6. or after using
the program No. 2.
u_ioctrl ( start ) ret = 0000
= 0001 (If the driver is not exist, No more message and to be error end.)
= 0002 (Version for driver)
= 0001 (If the I/O-PB board is not exist, No more message and error end.)
DIAG For I/O-PB-12 Ver 0.03
(Connection Less) 15:
(Connection Less) 16:
Not allowed
Not allowed
:
=>
— 15 —
*
CPU TEST
11:
CPU Software RESET & Set DIAG Mode
12:
ROM Sum Check
13:
RAM Check ( Write & Read )
14:
RAM Check ( Read only )
Ram Check ( Write & Read/ Repeat )
Ram Check ( Read only
17:
KP_PRINT_OUT
18:
KP_PRINT_OUT ( Repeat )
19:
ROM & RAM & KP
98:
DRV INF
99:
END
*
*
/ Repeat )
Advertisement
Table of Contents
