Setting Extra Suction Time - Buffalo CC770 Instruction Manual

SETTING EXTRA SUCTION TIME

1. Again, make sure machine is switched On [l] and the lid is raised
2.
Simultaneously press and hold the
Note: if not pressed at the same time you may accidentally select a different mode – check
that you are still in the mode you want to customise
3. Then, U (CC770) / TEU (CC771) alternates with the extra suction time on the display
Note: expressed in seconds as 1 to 9 then A to F on CC770 (A for 10, B for 11, C for 12, D
for 13, E for 14 and F for 15) and as 1 to 15 on CC771
4. To adjust the Extra Suction time, press and hold the
Note: the default Suction Time is 90 seconds and cannot be reduced
Note: constant use of extended Suction Time will shorten the life of the appliance
5. Press and hold the 'STOP/OK'
6. You are now back to the operating mode selected with its default Sealing Time being
displayed
VACUUM PACKING FOOD
1. Place the food in the bag
Note: never fill bag over 70% capacity
2. Remove any excess liquid or food residue
3. Lift the into locked position
4. Place the open end of the bag over
the Channel
5. Lower the lid and press on the lid to start
the suction process
6. Maintain pressure on the lid during full cycle
7. CC771 only – pressure is displayed before
sealing countdown begins
8. When the suction time has elapsed or when you press 'WELDING M1-M2-M3' or when
there is no air left in the bag... then the sealing process begins
Note: the process can be stopped at any time by pressing the STOP/
Note: the sealing can be started as early as you want by pressing 'WELDING M1-M2-M3'
9. CC770 – 'E' for End is displayed once process is completed, lift lid and remove bag
CC771 – 'END' is displayed once process is completed, lift lid and remove bag
WARNING: Never lift the lid from underneath as the sealing bar remains hot.
Make sure to ALWAYS lift it from the side to avoid injuries
Note: the lid may be hard to open for a few seconds after operation due to vacuum pressure
and you may need to allow a few seconds for the pressure to dissipate before lifting the lid
SAFETY FEATURES
Safety Cut-out: this appliance is fitted with an automatic safety system to help prevent
any damage from misuse – if during the suction process the pressure gets too great (no air
left in the bag) the appliance automatically switches to the sealing process.
Anti-stress Safety: this appliance is also fitted with an automatic anti-stress safety system
to help prevent any damage from overuse – if machine alternatively displays 'E' followed by
'A', leave the machine on for 10 minutes as it will then automatically turn off the machine
and reset the counter.
have been used 5 times consecutively
AUTO-STANDBY
If no cycle has been started within 4 ½ minutes, the Standby Mode kicks in. To switch the
machine back on, simply press any button for 1 second and wait up to 10 seconds.
and 'Welding M1-M2-M3' buttons for 3 seconds
button for 2 seconds to save the suction time and exit
E.g. the Anti-stress Safety kicks in after M1 or M2 (extreme modes)
Telephone Helpline: 0845 146 2887 (United Kingdom)
or buttons for ½ a second
OK
button
6