Installing And Removing An Rsp Module - Cisco ASR 903 Installation Instructions Manual

Installing and Removing an RSP Module

Step 3
Pull the fan tray backward toward you no more than 1 inch to disengage it from the power receptacle on the midplane,
as shown in this figure .
Figure 15: Fan Tray Removal
The fans might still be turning when you remove the fan assembly from the chassis. Keep fingers, screwdrivers,
Danger
and other objects away from the openings in the fan assembly's housing. Statement 263
Step 4
Wait at least 5 seconds to allow the fans to stop spinning. Then, pull the fan tray backward toward you and out of the
chassis.
As the fan tray slides out the chassis, support the bottom of the fan tray with one hand and keep your other hand on the
fan tray handle. To install the new fan tray, follow the steps in the
Installing and Removing an RSP Module
Follow these steps on handling an RSP module in the Cisco ASR 903 Router as a satellite shelf:
Installing an RSP Module
To install an RSP module in the router chassis, perform the following steps:
Cisco ASR 9000 Series Aggregation Services Router Satellite Systems Installation Guide
34
Installing the Cisco ASR 903 Router as a Satellite Shelf
Installing the Fan Tray, on page 31 section.