Installing the LAN Hub
An eight-port LAN hub is included in the PTM Upgrade Kit. It comes pre-assembled in its own
bracket for installation at the side of a rack enclosure. The LAN hub is used to connect each
installed library to a WAN via the 10-BaseT connector on the library controller board for
coordinating PTM operation and communication.
To install the LAN hub:
1.
Install cage nuts/clip nuts as indicated in
2.
Carefully install the LAN hub bracket.
Figure 1
Installing the LAN hub into a standard 7000/9000/10000 rack enclosure
Front of rack enclosure
Figure 1
through
Figure
1
MSL6000 series pass-through mechanism reference guide
4.
13