Fig.24 - Makita HW1200 Instruction Manual

NOTICE:
Be careful not to pull the trigger gun
forcibly during operation. It may cause the high
pressure washer to fall over.
After operating
CAUTION:
After operating, always perform
the procedure described in this manual. Residual
pressure in the trigger gun or high pressure washer
can cause personal injury or damage to the pump
inside.
1. After operating, leave the power switch on.
2. Close the faucet and disconnect the water hose
from the high pressure washer.
► Fig.26
3. Squeeze the trigger until the remaining water in
the high pressure washer is discharged.
Do not run the motor for longer than 1 minute.
► Fig.27
4. Switch off the high pressure washer and unplug it
from the mains.
► Fig.28: 1. Power switch
5. Disconnect the high-pressure hose from the trig-
ger gun.
► Fig.29: 1. Trigger gun 2. High-pressure hose
For the HW1200, also disconnect the high pressure
hose from the high pressure washer.
► Fig.30: 1. High pressure hose
For the HW1300, reel the hose and fix the end of the
hose.
► Fig.31: 1. Catch 2. Handle
NOTICE:
To prevent the high-pressure hose from
being damaged, remove the remaining water in
the hose before storing.
MAINTENANCE &
STORAGE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Cleaning the nozzle
Use the cleaner pin to remove dirt from or unclog the
nozzle.
► Fig.32: 1. Cleaner pin
NOTICE:
Do not remove dirt or debris forcibly.
This may result in personal injury or damage to the
ejection hole causing deviated jet angles or poor
performance.
Cleaning the filter
Detach the water hose connector and remove dirt and
debris from the inside of the filter.
► Fig.33: 1. Water hose connector 2. Filter 3. Sealing
ring
When using the suction hose set (optional accessory),
take the filter out of the filter case and remove dirt and
debris.
► Fig.34: 1. Filter 2. Filter case
NOTE: To maintain the optimal performance, clean
the filter periodically.
Storage
Reel the hose and cord. Put the trigger gun and nozzles
in the pockets.
HW1200
► Fig.35
HW1300
► Fig.36
CAUTION:
Always store in an indoor location
where the temperature does not go below freez-
ing. If the high pressure washer freezes and malfunc-
tions, contact your local service center for repairs.
CAUTION:
Always use the carrying handle
when moving the high pressure washer. Do not
carry it by the hose or cord. The hose or cord may
be damaged.
CAUTION:
Do not carry the high pressure
washer with the hose and/or cord unreeled. The
extended hose or cord may be damaged or entan-
gled with other objects, resulting in personal injury or
breakage.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
14 ENGLISH