Fig.1 - Makita HW1200 Instruction Manual

Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
SAFETY WARNINGS
WARNING:
Read all safety warnings and
all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instruc-
tions for future reference.
Work area safety
1. Keep operating area clear of all persons.
2. Do not overreach or stand on unstable sup-
ports. Keep good footing and balance at all
times.
3. Always place the high pressure washer body
on a level and stable surface. Avoid areas
where the ejected water will run or pool.
4. Before cleaning, check the surroundings and
objects to be cleaned. High pressure jets can
scrape away paint or other surface treatments
including toxic chemicals. Take the preventive
measures if necessary.
5. Be careful not to trip over by the cord or hose
of the high pressure washer. Always be aware
of the configuration of the cord and hose
during operation.
6. During use, a small amount of water will come
out from the bottom of the high pressure
washer. Avoid locating the high pressure
washer in the areas where you don't want to
wet.
Personal safety
To protect against the jet and objects by the
1.
jet, operators should wear appropriate cloth-
ing such as safety boots, safety gloves, safety
helmets with visors, hearing protection, etc.
Do not use the high pressure washer within
2.
range of persons unless they wear protective
clothing.
To reduce the risk of injury, close supervision
3.
is necessary when the product is used near
children.
Water that has flowed through backflow pre-
4.
venter is considered to be non-potable.
Electrical safety
Never use the high pressure washer outdoors
1.
in the rain.
2. Never touch the mains plug and/or socket with
wet hands.
3. Do not use the machine if the supply cord or
important parts of the machine are damaged,
e.g. safety devices, high pressure hoses, or
the trigger gun.
Plug must match the outlet. Never modify
4.
the plug in any way. Do not use any adapter
plug with grounded tools. Unmodified plug and
matching outlet will reduce risk of the electric
shock.
5. Inadequate extension cords can be dangerous.
If an extension cord is used, it shall be suitable
for outdoor use, and the connection has to be
kept dry and off the ground. It is recommended
that this is accomplished by means of a cord reel
which keeps the socket at least 60 mm above the
ground.
Note the following when using extension
6.
cords:
• Use only extension cords that are
intended for outdoor use.
• Use only extension cords with an elec-
trical rating equal to or higher than the
rating of the product.
• Do not use damaged extension cords.
• Examine extension cords before use and
replace if damaged.
Do not abuse extension cords and do not
•
yank on cords to disconnect them.
• Keep cords away from heat and sharp
edges.
• Always disconnect the extension cord
from the receptacle before disconnecting
the product from the extension cord.
7. The electric supply connection shall be made
by a qualified electrician and comply with IEC
60364-1. It is recommended that the electric
supply to this machine should include either
a residual current device that will interrupt the
supply if the leakage current to earth exceeds
30 mA for 30 ms or a device that will prove the
earth circuit.
Power tool use and care
1. Read all the instructions before using the
product.
2. Know how to stop the high pressure washer
and bleed pressures quickly. Be thoroughly
familiar with the controls.
3. High pressure jets can be dangerous if mis-
used. The jet must not be directed at people,
live electrical equipment, or the machine itself.
4. This machine is not intended for use by per-
sons (including children) with reduced physi-
cal, sensory, or mental capabilities, or lack of
experience and knowledge.
5. Children should be supervised to ensure that
they do not play with the appliance.
Do not spray flammable and/or toxic liquids.
6.
This may cause an explosion, intoxication, or
damage to the machine.
Do not direct the jet against yourself or others
7.
in order to clean clothes or foot-wear.
8. High-pressure hoses, fittings and couplings
are important for the safety of the machine.
Use only hoses, fittings and couplings recom-
mended by the manufacturer.
9. Follow the instructions when changing
accessories.
10 ENGLISH