Table of Contents
Advertisement
Installation wizard
When alignment is complete at both ends, proceed as follows:
Procedure 5-25 Post-alignment actions
1
At each end of the link in turn, lock off and tighten all the adjustment bolts
as per the instructions provided with the antenna and check that the RSSI
voltage does not change. If it does change, repeat alignment for the affected
end.
At each end of the link, re-check that the ODU RSSI voltage is within the
2
range predicted by LINKPlanner.
3
Check that the Wireless Link Status as reported by the Step 6 Alignment
Page is 'Up' (green)
At each end of the link, check that the receive power reported by the Step 6
4
Alignment Page
5
If the requirements of steps 2, 3 and 4 are all met, continue to step 6. If any
of these requirements are not met, antenna alignment is not complete.
Please refer to the Trouble Shooting section
6
On Step 6 Alignment Page, select Alignment Complete
If antenna alignment cannot be performed now and must be deferred, select
7
Abandon Alignment. This cancels the Install Wizard without doing
alignment. The transmitter is muted and the Step 7: Alignment Abandoned
page is displayed
NOTE
5-104
(Figure
(Figure
(Figure
In the Step 6: Antenna Alignment page
Transmit power, receive power, vector error and link loss are presented
as an array of four elements. These elements represent the maximum,
mean, minimum and latest values respectively. The maximum, mean and
minimum are calculated over a running one hour period.
5-39).
5-38) is within the range predicted by LINKPlanner.
5-40).
(Figure 5-38
Chapter 5 Installation
Installing the link
on page 7-9.
(Figure
and
Figure
phn-1478_005v000
5-39).
5-39),
Apr 2010
Advertisement
Table of Contents
