Makita TD111D Instruction Manual page 7

CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
Changing the impact force
1
2
3
1. Hard 2. Soft 3.
5. Button
Impact force grade displayed
on panel
Hard
Soft
NOTE:
impact force and speed are the same as hard mode.
NOTE:
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
NOTE:
4
5
4. Changed in three steps
Maximum blows
-1
3,900 min
-1
1,600 min
-1
3,900 min
of rotation. Depress the reversing switch lever from the
terclockwise rotation.
tion, the switch trigger cannot be pulled.
changes in three steps.
driving screws with good control.
In this mode, the tool drives a screw with low-speed
tion speed increases and reaches the maximum speed.
For approximately one minute after releasing the switch
trigger, the impact force can be changed.
Purpose
speed are desired.
avoid screw thread breakage.
control.
7 ENGLISH
Example of application
tightening bolts.
ening small screws such as M6.
-
-
-
-