Advertisement
REPLACING THE BATTERY
5870API is powered by a 3-volt lithium battery. If the
battery voltage gets too low, the device sends a low battery
signal to the control panel. The 5870API consumes less
battery power when stationary than when in motion.
Maximum battery life will be obtained when used on
assets that are moved infrequently (e.g.; televisions,
paintings, sculpture, etc.)
Replace the battery with Ademco 469, Panasonic CR2
or Duracell DLCR2. Use of another battery may present
the risk of fire or explosion
1.
Using a screwdriver, release the case's retaining tabs.
2.
Carefully remove the sensor's cover. (see Figure 1)
INSERT TIP OF
SCREWDRIVER.
PUSH IN TO
RELEASE CLIP
Figure 1 – Replacing the 5870API Battery
3.
Check the battery polarity orientation before
installing (see Figure 2).
4.
Insert the battery securely in the sensor.
5.
Snap the sensor cover back in place.
+4
Figure 2 – Replacing the 5870API Battery
SPECIFICATIONS
Dimensions:
1.8" H x 1.7" W x 0.63" D
(45.72 mm x 43.18 mm x 16.02 mm)
Power:
Single 3V Ademco 469, Panasonic CR2 or Duracell DLCR2 Lithium
Battery
Environmental Conditions:
14° to 122°F (-10° to 50°C)
<90% RH (non-condensing)
MOUNTING NOTES
UL
UL
UL
UL
Note: Most consumer electronics with plastic cases are
1. To obtain proper performance with adhesive tapes, it
2.
3.
4.
5870API-005-V0
5870API-001-V0
- 3 -
3M VHB double –sided tape can be used on the
following surfaces: acrylic, polycarbonate, coated
polycarbonate, cellulose acetate butyrate, aluminum,
acrylic/polyurethane paint, galvanized, stainless and
enameled steel, rigid PVC, epoxy, polyester and
epoxy polyester paint, uncoated and silane coated
glass, glass epoxy, polybutylene terephthalate, nylon,
noryl (PPE) polyphenelene ether, and acrylonitrile
butadiene styrene.
manufactured from acrylonitrile butadiene styrene (ABS).
is important to ensure that the surfaces are dry and
free of grease and condensed moisture. Clean the area
where the sensor will be installed with a 50/50
mixture of water and isopropyl alcohol, and allow to
dry.
Replace the adhesive when relocating the device. Take
care to align the hole in the tape with the device's
tamper switch plunger. Additional mounting tape
squares are available in packs of 10; 5870APITAPE-B
general application tape.
Firm application pressure develops better adhesive
contact and helps improve bond strength, which is
achieved after 72 hours.
If using Loop 3 the device must be mounted
horizontally.
• 5870API is not watertight, and therefore should not
be used in damp locations.
• The device should not be installed in locations
where temperatures may drop below 14° F.
• 5870API is not intended for use on swinging doors.
1.7"
1.8"
REPLACE ADHESIVE WHEN RELOCATING THIS DEVICE
5870API
(Rear View)
TAMPER
5870API-003-V1
Advertisement
