Verifying Routes - Cisco Catalyst 2000 Configuration Handbook

86 Cisco LAN Switching Configuration Handbook
Note This section is an abbreviated look at establishing and maintaining routes. It is
intended as a reminder and not as a comprehensive configuration of routing protocols. A
Layer 3 switch works exactly like a router for maintaining routes. Refer to Cisco Field
Manual: Router Configuration by Cisco Press for more detailed configuration informa-
tion. For more general information on routing and routing technologies, see the "Further
Reading" section at the end of the chapter.

Verifying Routes

After you have configured a port for routing, use the following command to verify the
VLAN port assignments:
(privileged) show protocol route
The protocol option enables you to look at the routing table for a given protocol, such as
IP, IPX, or AppleTalk.
Further Reading
Refer to the following recommended sources for further information about the topics covered
in this chapter.
Layer 3 Switching (Routing) and Routing Updates
McQuerry, Stephen. Interconnecting Cisco Network Devices, Part 1 (ICND1): CCNA Exam
640-802 and ICND1 Exam 640-822, Adobe Reader, Second Edition. ISBN-10: 1-58705-589-9.
McQuerry, Stephen. Interconnecting Cisco Network Devices, Part 2 (ICND2): (CCNA Exam
640-802 and ICND exam 640-816), Adobe Reader, Third Edition. ISBN-10: 1-58705-564-3.
Doyle, Jeff. Routing TCP/IP, Volume 1, Second Edition. Cisco Press, ISBN-10: 1-58705-202-4.
Doyle, Jeff and Jennifer DeHaven Carroll. Routing TCP/IP, Volume II. Cisco Press, ISBN 1-
57870-089-2.
Hucaby, David and Steve McQuerry. Cisco Field Manual: Router Configuration. Cisco Press,
ISBN 1-58705-024-2.
WAN Interfaces
Route Switch Module Catalyst VIP2-15 and VIP2-40 Installation and Configuration Note:
http://www.tinyurl.com/7wasde.
Enhanced FlexWAN Catalyst Installation Guide: http://www.tinyurl.com/7nyg5k.
Enhanced FlexWAN Module Performance and Configuration Guide:
http://www.tinyurl.com/7ub6uk.
SPA Interface Processors: http://www.tinyurl.com/9d2lm5.