TURBO HD 5 MP Series Dome Camera User Manual UD06099N User Manual Thank you for purchasing our product. If there are any questions, or requests, do not hesitate to contact the dealer. This manual may contain technical incorrect places or printing errors, and the content is subject to change without notice.
Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
Page 3
Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions”. Warnings: Serious injury or death may occur if any of the warnings are neglected.
1 Introduction 1.1 Product Features The camera is applicable for both indoor and outdoor conditions, and the application scenarios include road, warehouse, underground parking lot, bar, etc.. The main features are as follows: High performance CMOS sensor Low illumination, 0.008 Lux@(F1.2, AGC ON), 0 Lux ...
Check whether the power supply is matched with your power output to avoid the damage. Make sure the wall is strong enough to withstand three times the weight of the camera and the bracket. If the wall is cement, you need to insert expansion ...
Type I Camera Figure 2-3 Fix the camera to the Ceiling 7. Connect the corresponding cables, such as power cable and video cable. 8. Power on the camera to check whether the image on the monitor is gotten from the optimum angle. If not, adjust the camera according to the figure below to get an optimum angle.
Page 7
Type I Camera Figure 2-6 Attach the Base Plate to the Bracket 6. Route the cables through the bracket. steps 6 to 9 of the 2.1 Ceiling Mounting to Repeat complete the installation. 2.3 In-Ceiling Mounting Before you start: You need to purchase an in-ceiling mounting bracket separately.
Before you start: You need to purchase an inclined base separately. Steps: 1. Drill 4 screw holes and the cable hole in the ceiling according to the holes of the inclined base. 2. Install the inclined base to the ceiling with supplied screws, as shown in Figure 2-9.
BRIGHTNESS EXPOSURE MODE GAIN DWDR EXPOSURE ANTI-FLICKER OUTPUT BACK MODE MODE WHITE BACK BALANCE MODE DAY/NIGHT BACK CONTRAST SET UP SHARPNESS VIDEO SETTINGS COLOR GAIN LANGUAGE MIRROR BACK RESET FOCUS SAVE & EXIT Figure 3-2 Main Menu Overview 5. Click the direction arrow to control the camera. 1).
Page 10
(National Television System Committee) is the analog television system that is used in most of North America, parts of South America, Myanmar, South Korea, etc. Note: NTSC/PAL is only available under the mode of 5 MEGA@12.5fps. 3.2 FOCUS Move the cursor to FOCUS, and press the Iris+ to enter the submenu.
Page 11
ANTI-FLICKER Set the ANTI-FLICKER as ON to prevent the image from flickering. 3.4.2 WHITE BALANCE White balance, the white rendition function of the camera, is to adjust the color temperature according to the environment. It can remove unrealistic color casts in the image.
Figure 3-7 VIDEO SETTING CONTRAST This feature enhances the difference in color and light between parts of an image. You can set the CONTRAST value from 1 to 10. SHARPNESS Sharpness determines the amount of detail an imaging system can reproduce. You can set the SHARPNESS value from 1 to 10.