Makita HS301D Instruction Manual page 9

Removing or installing circular saw
blade
2
1. Shaft lock 2. Hex wrench
CAUTION: Be sure the circular saw blade is
installed with teeth pointing up at the front of the
tool.
CAUTION: Use only the Makita wrench to
install or remove the circular saw blade.
To remove the circular saw blade, press the shaft lock
fully so that the circular saw blade cannot revolve and
use the wrench to loosen the hex bolt counterclockwise.
blade.
4
2
1
To install the circular saw blade, follow the removal pro-
cedure in reverse. BE SURE TO TIGHTEN THE HEX
BOLT CLOCKWISE SECURELY.
1
3
1
2
3
1. Hex bolt 2. Protrusion
6. Protrusion (bigger side)
NOTE:
When changing the circular saw blade, make sure to
also clean the upper and lower blade guards of accu-
mulated sawdust as discussed in the Maintenance
section. Such efforts do not replace the need to check
lower guard operation before each use.
Hex wrench storage
1. Hex wrench
When not in use, store the hex wrench as shown in the
5
6
4
3. Outer
1
ENGLISH 9