Confirm Settings & Reboot - Fujitsu ETERNUS CS800 S6 User Manual

1. Select one of the following options:
Option
Network Time Protocol (NTP)
Server
Manual Date & Time Settings Select this option to manually set the system date
2. In the Timezone drop-down box, select the time zone where the ETERNUS CS800 is
located.
3. Next to Time Format, select the format to use when displaying times (24 hours or 12
hours).
4. Click Apply.
6.3.5 Confirm Settings & Reboot
The Confirm Settings & Reboot page displays. If the settings below are correct, click Finish.
Otherwise click Previous and change settings.
ETERNUS CS800
Description
(Recommended) Select this option to synchronize the
ETERNUS CS800 with an NTP timeserver or pool. Then
select or specify a timeserver or pool.
Select a Timeserver Pool - (Recommended)
l
Select one of the well-known, geographically-
based NTP timeserver pools in the drop-down
box.
To select a timeserver pool, you must first specify
at least one DNS IP address on the Network page
(see "Network" on page
must specify the IP address of the timeserver
pool.
Specify a Timeserver or Pool - Type the name or
l
IP address of the NTP server or pool. (See
http://support.ntp.org
publicly available NTP servers)
To verify that the ETERNUS CS800 can communicate
with the NTP server or pool, click Test NTP.
and time.
Specify the New System Date by clicking the calendar
icon. Specify the New System Time using the drop-
down boxes.
6.3 Running the Getting Started Wizard
293). Otherwise, you
for information about
120