Cisco Asr 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference - Cisco ASR 9000 Series Command Reference Manual

Address Pool Service Commands
Examples
This is an example of configuring the address-range command for IPv4 in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv4 pool2
RP/0/RSP0/CPU0:router(config-pool-ipv4)# address-range 11.11.11.11 14.14.14.14
This is an example of configuring the address-range command for IPv6 in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv6 pool3
RP/0/RSP0/CPU0:router(config-pool-ipv6)# address-range 2001::1 2001::100
Related Commands
Command
pool ipv4, on page 92
pool vrf, on page 90
exclude, on page 82
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Description
Enables distributed address pool service on ipv4.
Enables distributed address pool service on vrf.
Specifies a range of IP addresses that distributed
address pool service should not assign to clients.
address-range
5.2.x
81