Cisco Asr 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference - Cisco ASR 9000 Series Command Reference Manual

Excessive Punt Flow Trap Commands
Command Default
None
Command Modes
EXEC mode
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
lpts
basic-services
Examples The sample output for the show lpts punt excessive-flow-trap ip command is:
RP/0/RSP0/CPU0:router# show lpts punt excessive-flow-trap ip
Interface: Bundle-Ether1.100
This table describes the significant fields shown in the display.
Table 13: show lpts punt excessive-flow-trap interface Field Descriptions
Field
Intf Handle
location
protocol
punt reason
penalty-rate
Intf Handle: 0x08000320
Protocol: IPv4/v6
Penalty Rate: 10 pps
Time Remaining: 14 mins 31 secs
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
show lpts punt excessive-flow-trap interface
Modification
This command was introduced.
Operation
read
read, write
Location: 0/6/CPU0
Punt Reason: Raw-default
Penalty Timeout: 15 mins
Description
The interface handler for the Bundle Ether interface.
The location of the interface.
Specifies if it uses the IPv4 or IPv6 protocol.
The reason to punt the excessive flow trap.
The penalty policing rate for a protocol in pps.
5.2.x
267