Connection Status - Pppoe - NETGEAR MR814V2 User Manual

Connection Status - PPPoE

If using PPPoE (PPP over Ethernet), a screen like the following example will be displayed when
the "Connection Details" button is clicked.
Figure 24: PPPoE Status Screen
Data - PPPoE
Connection
Physical A ddress The hardware address of this device, as seen by remote devices
on the Internet. (This is different to the hardware address seen by
devices on the local LAN.)
IP Address The IP Address of this device, as seen by Internet users. This
address is allocated by your ISP (Internet Service Provider).
Networ k Mask The Network Mask associated with the IP Address above.
PPPoE Link Status This indicates whether or not the connection is currently estab-
lished.
•
If the connection does not exist, the "Connect" button can be
used to establish a connection.
•
If the connection currently exists, the "Disconnect" button
can be used to break the connection.
Connection Log
•
The Connection Log s hows status messages relating to the
Conne ction Log
existing connection.
•
The most common messages are listed in the table below.
•
The "Clear Log" button will restart the Log, while the Refresh
Operation and Status
37
Wireless Router User Guide
button will update the messages shown on screen.
Buttons
Connect If not connected, establish a connection to your ISP.
Disconnect If connected to your ISP, hang up the connection.
Clear Log Delete all data currently in the Log. This will make it easier to read
new messages.
Refresh Update the data on screen.
Connection Log Messages
Message Description
Connect on D e mand Connection attempt has been triggered by the "Connect
automatically, as required" setting.
Manual connection Connection attempt started by the "Connect" button.
Reset physical connection Preparing line for connection attempt.
Connecting to remote Attempting to connect to the ISP's server.
server
Remote Server located ISP's Server has responded to connection attempt.
Start PPP Attempting to login to ISP's Server and establish a PPP con-
nection.
PPP up successfully Able to login to ISP's Server and establish a PPP connec tion.
Idle time -out reached The connection has been idle for the time period specified in
the "Idle Time -out" field. The connection will now be term i-
nated.
Disconnecting The current connection is being terminated, due to either the
"Idle Time-out" above, or "Disconnect" button being clicked.
Error: Remote Server not ISP's Server did not respond. This could be a Server problem,
found or a problem with the link to the Server.
Error: PPP Connection Unable to establish a PPP connection with the ISP's Server.
failed This could be a login problem (name or password) or a Server
problem.
Error: Connection to Server The existing connection has been lost. This could be caused
lost by a power failure, a link failure, or Server failure.
Error: Invalid or unknown The data received from the ISP's Server could not be proc-
packet type essed. This could be caused by data corruption (from a bad
link), or the Server using a protocol which is not supported by
this device.
38