NETGEAR MR814V2 User Manual page 11

•
WEP (Wired Equivalent Privacy) status will display "Enabled" or
WEP data
"Disabled", depending on whether WEP is being used. If used,
e ncryption
data is Encrypted before being transmitted, making communic a tion
more secure.
•
Click the "Configure WEP" button to access the WEP sub-screen,
and view or change the WEP settings.
Access Point
•
All Wireless Stations - All wireless stations can use the access
Allow LAN
point to access your LAN.
access by ...
•
Selected Wireless stations only - Only selected wireless stations
access your LAN. To select the required wireless stations, click the
"Select Stations" button.
•
All Wireless Stations - All wireless stations can use the access
Allow Internet
point to access the Internet.
access by ...
•
Selected Wireless stations only - Only selected wireless stations
use the access point to access the Internet. To select the required
wireless stations, click the "Select Stations" button.
Buttons
Configure WEP Click this button to view the WEP sub-screen. See the following section
for more details.
Select Stations Click this button to select the required PCs.
Save Save the data on screen.
Cancel The "Cancel" button will discard any data you have entered since the
last "Save" operation.
Setup Wireless Router User Guide
WEP Screen
This screen is accessed by clicking the "Configure WEP" button on the Wireless screen. An
example WEP screen is shown below. Note that in IE, the "Key Table" is only displayed when
required.
Data - WEP Screen
WEP Data Encryption
Authentication
Type
Encryption
17
Figure 8: WEP Screen
Select the appropriate value - "Open System" or "Shared Key". Check
your Wireless card's documentation to see what method to use. Some
Wireless cards do not support both methods.
Off
•
If OFF (default), data is NOT encrypted before being transmitted.
64 Bit Encryption
•
If selected, data is encrypted, using the default key, before being
transmitted. The receiving station must be set to use 64 Bit Encryp-
tion, and have the same Key value in the same position in its key
table. Otherwise, it will not be able to decrypt the data.
•
Default Key - select the key you wish to be the default. Transmi t ted
data is ALWAYS encrypted using the Default Key; the other Keys
are for decryption only.
•
Key Table:
•
This table is used when Encrypting and Decrypting data. All
stations, including this Access Point, always transmit data e n-
crypted using their default key. The key number (1, 2, 3, 4) is
also transmitted. The receiving station will use the key number
(1, 2, 3, 4) to determine which key value to use for decryption.
18