Advertisement
Operation
9.
Always direct the cable to the rear away from the
appliance.
10. If a cord becomes damaged during use, dis-
connect the supply cord from the mains imme-
diately. DO NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
11.
Do not carry the appliance by the cable.
12. Disconnect the appliance from the mains supply.
—
whenever you leave the machine;
—
before clearing a blockage;
—
before checking, cleaning or working on the
appliance;
—
if the appliance starts to vibrate abnormally.
—
Do not block suction inlet or blower outlet
to clean up in dusty areas.
—
Do not use the blower with a tapered
nozzle smaller than the original one, such
as a new nozzle obtained by attaching an
extra diameter-reduced hose or smaller
hose to the nozzle top end.
Do not Use the blower to inlate balls,
—
rubber boat or the similar.
13. Operate the appliance only in daylight or in good
artiicial light.
14. Do not overreach and keep your balance at all
times.
15. Always be sure of your footing on slopes.
16. Walk, never run.
17. Keep all cooling air inlets clear of debris.
18. Never blow debris in the direction of bystanders.
19. Never block suction inlet and/or blower outlet.
Increased motor revolution may cause dangerous
fan breakage and result in serious personal injury.
Heated motor and control circuit may cause a ire.
20. It is recommended to use the long nozzle so
the air stream can work close to the ground.
Maintenance and storage
21. Keep all nuts, bolts and screws tight to be sure the
appliance is in safe working condition.
22. Check the debris collector frequently for wear or
deterioration.
23. Replace worn or damaged parts.
24. Use only genuine replacement parts and
accessories
25. Store the appliance only in a dry place.
SAVE THESE INSTRUCTIONS.
WARNING: DO NOT let comfort or famil-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and unplugged
before adjusting or checking function on the tool.
Switch action
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
2
► 1 . Switch trigger 2. Speed control screw 3. Higher
4. Lower 5. Lock button
To start the tool, simply pull the switch trigger. Tool speed is
increased by increasing pressure on the switch trigger. Release
the switch trigger to stop. Switch can be locked in "ON" position
for ease of operator comfort during extended use. Apply caution
when locking tool in "ON" position and maintain irm grasp on tool.
For continuous operation, pull the switch trigger, push in
the lock button and then release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
A speed control screw is provided so that maximum tool speed
can be limited (variable). Turn the speed control screw clock-
wise for higher speed, and counterclockwise for lower speed.
OPERATION
3 ENGLISH
1
4
3
5
Advertisement
