Table of Contents
Advertisement
Routing Information Protocol configuration
The RIP commands are used for configuring Routing Information Protocol parameters. This option is turned off by
default.
The following table describes the basic RIP Configuration commands. The following section provides more detailed
information and commands.
Table 129 RIP Configuration commands
Command
router rip
timers update <1-120>
enable
no enable
show ip rip
RIP Interface configuration
The RIP commands are used for configuring Routing Information Protocol parameters. This option is turned off by
default.
NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interface Configuration commands.
Table 130 RIP Interface Configuration commands
Command
ip rip version {1|2|both}
[no] ip rip supply
[no] ip rip listen
[no] ip rip poison
[no] ip rip split-horizon
[no] ip rip triggered
[no] ip rip multicast-
updates
Description
Enter router RIP configuration mode.
Command mode: Global configuration
Configures the time interval for sending for RIP table updates, in seconds.
The default value is 30 seconds.
Command mode: Router RIP
Globally turns RIP on.
Command mode: Router RIP
Globally turns RIP off. This is the default.
Command mode: Router RIP
Displays the current RIP configuration.
Command mode: All except User EXEC
Description
Configures the RIP version used by this interface.
2
The default value is version
.
Command mode: Interface IP
When enabled, the switch supplies routes to other routers. This command is
enabled by default.
Command mode: Interface IP
When enabled, the switch learns routes from other routers. This command is
enabled by default.
Command mode: Interface IP
When enabled, the switch uses split horizon with poisoned reverse. When
disabled, the switch uses only split horizon. This command is disabled by
default.
Command mode: Interface IP
Enables or disables split horizon. The default value is
Enables or disables Triggered Updates. Triggered Updates are used to speed
convergence. When enabled, Triggered Updates force a router to send
update messages immediately, even if it is not yet time for the update
message. The default value is
Command mode: Interface IP
Enables or disables multicast updates of the routing table (using address
224.0.0.9). The default value is
Command mode: Interface IP
N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (ISCLI) 119
enabled
enabled
.
enabled
.
.
Advertisement
Table of Contents
