Bevel Cutting - Makita DSP600 Instruction Manual

1
► 1 . Blade lower limit stopper 2. Clamping screw
Quick stop button for 2 to 3 mm
depth of cut when using guide rail
(optional accessory)
This tool has the quick stop button for 2 to 3 mm depth
of cut on the gear housing aside the rear handle when
using guide rail. This is used when avoiding splinter on
the workpiece in the cut. Make a pass of the 2 to 3 mm
first cut and then make another pass of usual cut.
1
► 1 . Quick stop button
To obtain the 2 to 3 mm depth of cut, push in the quick
stop button toward the saw blade. This is convenient for
avoiding splinter on the workpiece.
To release the depth of cut from this position for free
depth of cut, just pull the button back.

Bevel cutting

Loosen the clamping screws. Set for the desired angle by
tilting accordingly, then tighten the clamping screws securely.
2
► 1 . Clamping screw 2. Bevel scale plate
1
► 1 . Sub base (Optional accessory) 2. Clamping screw
Positive stopper
The positive stopper is useful for setting the designated angle
quickly. Turn the positive stopper so that the arrow on it points
22.5°. Loosen the clamping screws in front and back. Then tilt the
blade until it stops and secure the base with the clamping screws.
► 1 . Positive stopper 2. Clamping screw
10 ENGLISH
1
2
1
1
2
2
2