Rotating Gobo Replacement - Philips VL1000 TS Service Manual

VARI❋LITE® - VL1000™ ERS L

Rotating Gobo Replacement

WARNING: Remove power from luminaire before performing maintenance. Gobos
may be HOT after operation. Allow to cool before replacing.
WARNING:
use of metal gobos in any VARI
luminaire's warranty.
To replace a rotating gobo:
Step 1. Remove power from luminaire.
Step 2. At either side of head assembly, press in front cover latch and pull cover
Step 3. Rotate gobo wheel until required gobo position is accessible at finger access
Step 4. Rotate gobo gear until open end of carrier is upward.
CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or other
covering while replacing. Clean with glass cleaner and soft cloth if required.
CAUTION: Do not pull metal spring clip carrier back too far or it will not close
properly.
Step 5. If applicable, carefully pull current gobo up and out of carrier. Gobo can be
Step 6. Carefully install new gobo, orienting side marked "This Edge In" toward
Step 7. Re-install front cover.
28
S
UMINAIRE ERVICE
❋
Users of VARI LITE luminaires should not install or use metal gobos. The
❋
LITE product may damage the luminaire and could void the
straight back until stopped by tether
cutout (Figure 2-9).
easily scratched on sides of carrier if not careful.
center of gobo wheel and side marked "Lamp Side" (mirror finish) toward
lamp. Gobo can be easily scratched on sides of carrier if not careful. Ensure
gobo is firmly set in carrier grooves.
14-May-2009
M
ANUAL
(Figure 2-7).
02. 96 63. 001 0 F