Led Descriptions - Cisco MDS 9000 Installation And Configuration Note

Hardware Description
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

LED Descriptions

The PAA has five LEDs on its faceplate (see
Table 1
Table 1
LED Type
Status
Fibre Channel Link
Fibre Channel Speed Off
100-Mbps Ethernet
1-Gbps Ethernet
Cisco MDS 9000 Family Port Analyzer Adapter Installation and Configuration Note
6
lists the LEDs, their conditions, and what the conditions indicate.
LED Descriptions
Status
Off
Red
Green
Off
Green
Green
Off
Green
Blinking green
Off
Green
Blinking green
Figure 2).
Description
Either the power to the adapter is off or there is a power
failure. The adapter cannot power up.
Power is up, but there is some other failure.
To attempt to fix the failure, power cycle the adapter by
powering off and waiting for more than four seconds
before powering on. To power cycle, disconnect the
power cord from the wall rather than from the adapter.
The adapter is functioning correctly.
The Fibre Channel link is down.
The Fibre Channel link is up.
The Fibre Channel link is programmed in 1-Gbps mode.
The Fibre Channel link is programmed in 2-Gbps mode.
The Ethernet link is down. The link speed might not be
negotiated.
The LED is off when Ethernet is configured in 1-Gbps
mode.
The Ethernet link is up in 100-Mbps mode.
Ethernet frames are being transmitted on the Ethernet
link.
The Ethernet link is down. The link speed might not be
negotiated.
The LED is off when Ethernet is configured in
100-Mbps mode.
The Ethernet link is up in 1-Gbps mode.
Ethernet frames are being transmitted on the Ethernet
link.
OL-9077-01