Cisco MDS 9000 Installation And Configuration Note page 12

Port analyzer adapter

Hide thumbs Also See for MDS 9000:

Table of Contents

Installing the Port Analyzer Adapter

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Installing the Port Analyzer Adapter

Before you install, operate, or service this equipment, read the Regulatory Compliance and Safety

Note

Information for the Cisco MDS 9000 Family for important safety information.

To install the Cisco MDS 9000 Family Port Analyzer Adapter, follow these steps:

Configure the DIP switch settings at the rear of the adapter. See

Step 1

and modes of operation.

Step 2

Connect the AC power converter to the rear of the adapter.

Connect the left (Fibre Channel) port on the adapter to the Fibre Channel SD port on the switch (see

Step 3

Figure

connector to the switch and another LC connector to the adapter.

Cisco MDS 9000 Family Port Analyzer Adapter Installation and Configuration Note

6). Use regular multimode fiber with LC to LC connectors (see

Table 2 on page 7

for DIP switch settings

Figure

7). Attach one LC

OL-9077-01

Table of Contents