Honeywell N-1000 Settings Manual page 6

Setting up controller of
1. Go to setting panel of
2. Set connection parameters of controller:
a. Set controller address in
b. From Panel type
3. In Facility codes
4. Select format of linking access card number and organization code (facility code) from the corresponding dropdown
list ( ). 4
Note.
If there is no need to link access card number and organization code it's necessary to set
5. Set up user access through PIN code:
a. Set Allow
b. From the corresponding dropdown list select time zone during which it's necessary to ask PIN code of the
user while giving the access ( ).
6. Set up basic controller options:
6
HoneyWell N-1000 ACS is carried out the following way:
N1000 panel object.
Panel address 1
dropdown list select type of connected controller ( ).
set codes used by organization (facility codes) ( ).
checkbox if it's necessary to ask PIN code of the user while giving the access ( ).
6
( ).
3
2
None
5
value.