Table of Contents
Advertisement
2.
Set entrance address in
3.
From
Entrance
4.
In
Bypass
setting group set parameters of entrances disconnection:
a.
In
Duration
b.
From corresponding dropdown list select time zone during which entrance disconnects automatically ( ).
5.
Set delay of bounce of entrance contacts (in seconds) in the corresponding field ( ).
6.
If it's necessary to switch on
ame
dropdown lists ( ).
7.
If it's necessary set time zone during which there will be no interactions connected with this entrance ( ).
8.
If it's necessary to require confirmation while activating entrance then set
during which the confirmation should be received and select time zone during which the confirmation will be
required ( ).
8
9.
If it's necessary to activate buffering mode then set
will be active ( ).
9
10.
If it's necessary to disable alarm messages then set
be the prohibition (
11.
Set
Alarm/normal state inversion
versa (
11
).
12.
If it's necessary to limit incoming messages by damage-only messages then set the corresponding checkbox (
13.
Click
Apply
in order to save changes (
Setting up entrance is completed.
Creation and setting up of entrance groups
Setting up entrance groups is carried out on setting panel of
000 panel
object on
Hardware
Setting up entrance groups is carried out the following way:
13
Address 1
( ).
dropdown list select type of entrance ( ).
field set period during which entrance will be disconnected ( );
Auto lock
function set
6
10
).
checkbox if it's necessary to substitute
13
).
tab of
System settings
2
Allow
checkbox and select necessary object from
Allow
Allow
checkbox and select time zone during which this mode
Disable
checkbox and select time zone during which there will
N1000 zone
object. This object is created on the basis of
dialog box.
3
5
Type
7
checkbox, set period of time
Alarm
state with
Normal
4
and
N
and vice
12
).
N1
Hide quick links:
Advertisement
Table of Contents
