Setting Up Honeywell N-1000 Entrances; Creation And Setting Up Of Entrances - Honeywell N-1000 Settings Manual

2. Set address of exit group in the corresponding field ( ).
3. Set checkboxes opposite those exits that should be in the group ( ).
4. In Impulse setting group set parameters of exit group impulse:
5. In Duration field set the period during which power supply (impulse) will be given to exit group ( );
6. From the corresponding dropdown list select time zone during which power supply will be given to exit group
automatically ( ). 4
7. If it's necessary set time zone during which there will be no interactions connected with this exit group ( ).
8. If it's necessary select warning group from the corresponding dropdown list ( ).
9. If it's necessary set this group as a special group for exit: set
list ( ). 7
10. Click Apply in order to save changes ( ).
Setting up exit groups is completed.

Setting up HoneyWell N-1000 entrances

Creation and setting up of entrances

Setting up entrances is carried out on setting panel of
00 panel object on Hardware
Setting up entrances is carried out the following way:
1. Go to setting panel of
12
8
N1000 entrance
tab of System settings
N1000 entrance object.
1
2
Allow checkbox and select necessary object from the
object. This object is created on the basis of
dialog box.
3
6
5
N10