Cisco ASR 1013 Hardware Installation Manual page 434

Connecting DC Input Power to Cisco ASR 1013 Router
b) Tighten the Kepnut screws on the power supply studs.
Figure 192: Cisco ASR 1013 Router DC Power Supply Grounding Stud and Cable
1
2
3
Shielded cables must be used to connect to the DB-25 alarm connector on both the AC and DC power
Note
supplies in order to comply with FCC/EN55022/CISPR22 Class A emissions requirements. See the "How
Cisco ASR1000-RP Alarm Monitoring Works" section.
Step 3
Attach the other end of the cable to the site's ground connection.
Step 4 Remove the plastic cover from the terminal block.
Caution Before you continue to install the terminal block ground wires, stop and perform Step 5. To prevent any
contact with metal lead on the ground wire and the plastic cover.
Cisco ASR 1000 Series Router Hardware Installation Guide
400
DC power supply
grounding stud with wire
Grounding screws
DC Power supply ground
symbol
Cisco ASR 1013 Router Overview and Installation
4
5
—
Flat washer
Kepnut screw
—