Section 1
Introduction
1.5
14
•
the character ^ in front of an input/output signal name indicates that the signal
name may be customized using the PCM600 software.
•
the character * after an input signal name indicates that the signal must be
connected to another function block in the application configuration to achieve
a valid application configuration.
•
Logic diagrams describe the signal logic inside the function block and are bordered
by dashed lines.
•
Signals in frames with a shaded area on their right hand side represent setting
parameter signals that are only settable via the PST or LHMI.
•
If an internal signal path cannot be drawn with a continuous line, the suffix -int
is added to the signal name to indicate where the signal starts and continues.
•
Signal paths that extend beyond the logic diagram and continue in another
diagram have the suffix "-cont."
•
Dimensions are provided both in inches and mm. If it is not specifically mentioned
then the dimension is in mm.
IEC61850 edition 1 / edition 2 mapping
Table 1:
IEC61850 edition 1 / edition 2 mapping
Function block name
AEGPVOC
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BCZSPDIF
BCZTPDIF
BDCGAPC
BRCPTOC
BRPTOC
BTIGAPC
BUSPTRC_B1
BUSPTRC_B2
BUSPTRC_B3
Table continues on next page
Edition 1 logical nodes
AEGGAPC
AGSAL
SECLLN0
ALMCALH
BCZSPDIF
BCZTPDIF
SWSGGIO
BRCPTOC
BRPTOC
B16IFCVI
BUSPTRC
BBSPLLN0
BUSPTRC
BUSPTRC
1MRK 511 366-UUS -
Edition 2 logical nodes
AEGPVOC
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BCZSPDIF
BCZTPDIF
BBCSWI
BDCGAPC
BRCPTOC
BRPTOC
BTIGAPC
BUSPTRC
BUSPTRC
BUSPTRC
Commissioning manual