✻
55 Enabling the 5842 Wireless Dialer
While in Program mode, press
The following explains the
available entries for each. The right-most column provides a further explanation of the entries.
Note: You may find it convenient to adjust the volume setting before entering the Programming Mode. This will allow you to clearly
hear feedback announcements or system beeps.
Enable the dialer
>
@ FRQWLQXH
)
G
✻
GLVDEOH
HQDEOH
Enable reports
>
@ FRQWLQXH
)
U
✻
>@ UHWXUQ WR SUHYLRXV SURPSW
GLVDEOH
HQDEOH
Response to phone line failure
>
@ FRQWLQXH
0
Q
✻
>@ UHWXUQ WR SUHYLRXV SURPSW
HQDEOH WURXEOH VRXQGHU
HQDEOH DODUP VRXQGHU
Enable back-up reporting
>
@ FRQWLQXH
)
E
✻
>@ UHWXUQ WR SUHYLRXV SURPSW
GLVDEOH
HQDEOH
✻
55 to enter Wireless Dialer Programming Feature .
✻
55 prompts in detail. The left two columns identify the prompts and list the
Enter [1] to enable the 5842 Wireless dialer. Press [
field.
Pressing 0 exits mode, upon which the prompt "55" blinks, indicating the
mode is inactive. Press [✻] + any field number to go to that field.
Enter [1] to enable reports. Press [
return to the previous prompt.
The following 5842 reports will be enabled:
• Loss of RF link with 5842 Wireless Dialer
• Tamper at 5842
• Low Battery at 5842
• AC loss at 5842 (if supported by the specific wireless dialer being
installed)
• Line Cut at 5842 (if supported by the specific wireless dialer being
installed)
Select the system response to detection of a line cut at the 5842 Wireless
Dialer.
Enter [1] to send alarm on a 5842 line cut. Enter [0] to enable trouble
sounder on a 5842 line cut. Press [
return to the previous prompt.
Allows Lynx to do back-up reporting for the 5842 wireless dialer.
to enable back-up reporting. Enter [0] to disable back-up reporting. [#} to
return to the previous prompt.
Note: Lynx must be connected to a secondary phone line or to the same
phone line via the 5842 Wireless Dialer.
–26–
✻
] to advance to next
✻
] to advance to next field or [#} to
✻
] to advance to next field or [#} to
Enter [1]