Husqvarna K 760 Workshop Manual page 9

4
3.2
1
3
1
9
DISMANTLING INTO BASIC MODULES
3.3
4
2
2
5
3
3.2. Dismantle the three screws on the air
duct cover.
3.3. Lift off the air duct cover.
Muffler
Dismantle the cutting head and the
starter.
1. Dismantle the four screws on the
muffler.
2. Dismantle the muffler.
Fit the gaskets correctly!
3. The insulated fibre gasket should lie
closest to the muffler.
4. Fit the heat shield.
5. The aluminium gasket should lie
against the cylinder.
The screws should be tightened to a
torque of 8.0–9.5 lbf·ft/11–13 Nm.
Vibration dampening
Some service work can be aided by split-
ting the machine by the vibration dampe-
ning element.
Dismantle the air filter unit, cylinder
cover and upper the air duct cover.
Dismantle the screw holding the carbu-
rettor. Dismantle the starter and the air
duct cover. Loosen the cable lug by the
ignition module and unscrew the cable
to the earth point. Pull off the water hose
by the valve.
The engine unit is attached to the
handle unit at three points with the vib-
ration dampening element in the form of
springs. Dismantle the screws located by:
1. The lower section on the flywheel side.
2. The base on the clutch side.
3. The handle loop next to the water
valve.
To gain access to the spring's inner
screw, Torx T27, the tool diameter must
be max. 5 mm. The combination spanner
fits.