Husqvarna K 760 Workshop Manual page 24

2
9
8
6
7
12
11
CARBURETTOR
4
1
5
13
Dismantling/
assembling
Dismantling the air valve
Dismantle the air valve if the
work demands this.
Link rod
Note the attachment of the link
rod when reassembling.
Turn the gasket correctly!
Make sure that the gasket faces
the right way so the channel is
not covered.
Components
1. Throttle valve
2. Air valve
3. Choke valve
4. Pulse line, to the carburettor's
pump diaphragm
5. Fuel line
6. Connection to air purge
3
7. High and low speed jet (set at the
factory)
8. Idle screw, speed adjustment
10
9. Throttle rod for the choke
10. SmartCarb filter compensation
11. Pump diaphragm
– on top in relation to the crankcase
via the pulse line
– fuel under the diaphragm
12. Fuel pump's valve flaps
13. Fuel chamber, measurement
chamber diaphragm above
14
14. Needle valve for pressure
regu lator
Dismantling/assembling
Dismantling the air valve
The air valve is secured on the carburet-
tor by two screws.
The air valve does not need to be dis-
mantled to check the function of the
carburettor or for most service work.
However, dismantling the air valve facili-
tates accessibility.
Link rod
Note the attachment of the link rod
when reassembling.
Turn the gasket correctly!
Make sure that the gasket faces the right
way so the channel at the arrow is not
covered.
The channel connects the filter chamber
with the carburettor's measuring chamber
on the dry side, to the cover. (SmartCarb
filter compensation.)
10
24