Before Using Your Vcr 5; Erasure Prevention - Philips SV2000 SVA106 Owner's Manual

Putting Batteries in the Remote Control
1
Remove the battery compartment lid on the bottom of the
remote control by sliding the lid in the direction of the arrow.
2
Insert two AA batteries inside the battery compartment with
their + and – ends aligned as indicated.
3
Replace the battery compartment lid.
Using the Remote Control
Point the remote control at the VCR's remote sensor (see page
21) when using the remote control to operate the VCR.
Do not put objects between the remote control and the VCR.

Erasure Prevention

Video cassette tapes have record tabs to ensure that recordings
are not erased accidentally.
1
To prevent accidental erasure, break off the tab with a screwdriv-
er.
2
To record again, cover the hole with cellophane tape.
VCR maintenance
In this VCR, use only tapes with the
Make sure any light adhesive stick-on notes are removed from
the video cassette tape before putting the tape in the VCR.
Removable labels like these can jam the VCR.
Periodic maintenance is required to maintain your VCR's per-
formance. The video heads will eventually require cleaning or
replacement. Cleaning or replacement of the video heads
should be performed by an authorized service center.
mark.

Before Using Your VCR 5

1
2
3
1
2
Helpful Hints
• The remote control and its batteries
are supplied.
• Do not mix alkaline and man-
ganese batteries.
• Do not mix old and new batteries.