Connecting The Tv-Video Combi; Important For The United Kingdom; Preparing The Remote Control For Operation; Connecting The Cable - Philips TV-Video Combi 14PV374/07 Operating Instructions Manual

Philips tv-video combi product manual
Table of Contents

Advertisement

1. Connecting the TV-Video Combi

Important for the United Kingdom

This apparatus is fitted with an approved 5 Amp
plug. To change a fuse in this type of plug pro-
ceed as follows:
1.Remove fuse cover and fuse.
1.
2.Fix new fuse which should be a BS1362
2.
5A,ASTA or BSI approved type.
3.Refit the fuse cover.
3.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should
have a value of 5A. If a plug without a fuse is
used, the fuse at the distribution board should not
be greater than 5A.
The severed plug must be destroyed to avoid a pos-
sible shock hazard should it be inserted into a 13A
socket elsewhere.
How to connect a plug:
The wires in the mains lead are coloured in accor-
dance with the following code:
BLUE- 'NEUTRAL' ('N')
BROWN- 'LIVE' ('L')
4.The BLUE wire must be connected to the termi-
4.
nal which is marked with the letter 'N' or
coloured BLACK.
5.The BROWN wire must be connected to the
5.
terminal which is marked with the letter 'L' or
coloured RED.
6.Do not connect either wires to the earth termi-
6.
nai in the plug which is marked with the letter
'E' or by the safety earth symbol
green or green-and-yellow.
Before replacing the plug cover, make certain that
the cord grip is clamped over the sheath of the
lead-not imply over the two wires.
Preparing the remote control for
operation
The remote control and
its batteries are packed
separately in the original
TV-Video Combi pack-
aging. You must install
the batteries in the remote control before use.
1.Take the remote control and the enclosed bat-
1.
teries (2 batteries).
2.Open the remote control's battery compart-
2.
ment and place the batteries in it as shown in
the picture and close the battery compart-
ment.
The remote control is now ready to use.
Its range is approximately 7 metres.
EN

Connecting the cable

1.
1.
Insert the aerial cable plug into the
AERIAL at the back of the TV-Video Combi.
2.
2.
Connect the mains cable to the wall socket.
3.
3.
If the little red standby light (STANDBY
the front panel of the set is not lit, please
switch on the set using the main power
switch. The power switch
left side panel of the set.
4.The following screen will appear on the TV.
4.
You can find more details in chapter 'Preparation
or coloured
for use'.

Connecting additional devices

You can connect additional devices such as
decoders, satellite receivers, camcorders, etc. to
the EXT1 socket.
The respective scart socket is usually marked
'AV' or 'TV' on the decoder or satellite receiver.
4
is located on the
PLEASE CONNECT AERIAL OR
CABLE TO THE TVCR
THEN...
PUSH P+ KEY
OR...
FOR PLAY ONLY PUSH PLAY
[14 inch]
) at
[14 inch]

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

21pv375/0714pv375/0714pv37521pv375

Table of Contents