Switch Button; Functional Description; Switch Trigger - Makita HR4003C Instruction Manual

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
number of blow
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.

Switch trigger

This switch functions when setting the tool in
and symbol modes.
► 1. Switch trigger
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.

Switch button

This switch functions when setting the tool in
mode.
► 1. Switch button
When the tool is in the
button projects out and lights in red.
To start the tool, press the switch button. The switch
light turns in green.
To stop the tool, press the switch button again.
Speed change
1
► 1. Adjusting dial
The revolutions and blows per minute can be adjusted
symbol
just by turning the adjusting dial. The dial is marked 1
(lowest speed) to 5 (full speed).
Refer to the table below for the relationship between the
number settings on the adjusting dial and the revolu-
tions/blows per minute.
For Model HR4003C, HR4013C
Number on
adjusting dial
5
4
3
2
1
4 ENGLISH
1
symbol mode, the switch
Revolutions per
Blows per minute
minute
500 2,900
470 2,700
380 2,150
290 1,650
250 1,450
symbol