Lighting The Side Burner - GE JGGN24 Owner's Manual

SIDE BURNER
OFF
IGNITOR
HI
Lighting the Side Burner (on some models)
WARNING:
Open lid before lighting.
TO LIGHT WITH THE IGNITOR:
1. Make sure control knobs are set to
OFF and turn on the gas supply by
opening the LP tank valve.
2. Push in and turn the control knob
to HI .
3. Push the ignitor button 3 or 4 times.
The burner should ignite within 4
seconds.
If the Side Burner Will Not Light
1. Turn control knobs to OFF .
Wait 5 minutes, then try again.
Shutting Down
1. Turn off the gas supply by closing
the LP tank valve.
2. Turn control knobs to OFF .
www.GEAppliances.com
TO LIGHT WITH A MATCH:
1. Make sure control knobs are set to
OFF and turn on the gas supply by
opening the LP tank valve.
2. Apply lighted match to the side
burner ports. It is important to have
lighted match near burner ports
BEFORE turning the control knob.
3. Push in and turn the control knob to
HI . The burner should ignite within
4 seconds.
2. If any burner will not light, consult
the Troubleshooting Tips section at
the back of this manual. If problem
cannot be resolved, do not attempt
to operate the grill. Contact a
GE Authorized Service Center.
9