Makita GA7911 Instruction Manual page 8

IF USED AS A GRINDER
NOTE :
Use grinder accessories specified in this manual. These must be purchased by separate.
WARN I NG
:
Always use guard assembly or accessory kit, noted below, for type 27 depressed center
wheel.
Guard assembly Guard accessory kit
Part No. 191214-3.
.
. For 180 mm (7")
Part No. 191215-1
. . .
For 230 mm (9")
Part No. 191228-2. .
.
For 180 mm (7")
Part No. 191231-3..
.
For 230 mm (9")
Installing or removing depressed center wheel
CAUTION :
Always be sure that the tool i s switched off and unplugged before installing or removing
the wheel.
Mount the inner flange onto the spindle.
Fit the wheel on over the inner flange and
I
I
Depressed
center wheel
screw the lock nut onto the spindle.
I
Inner flange
To tighten the lock nut, press the shaft
lock firmly
so
that the spindle cannot re-
volve, then use the lock nut wrench and
securely tighten clockwise.
To remove the wheel, follow the installation procedure in reverse.
8