S/Rf Meter - Cobra 29 LX MAX How To Use Manual

Operation
Setting Squelch
Continued
Gate set to Desired
Squelch Setting (DSS)
STRONG SIGNALS
MEDIUM SIGNALS
WEAK SIGNALS 3
To achieve the Desired Squelch Setting (DSS), turn
the Squelch control counterclockwise until you hear
noise. Now turn the control clockwise just until the
NOISE
noise stops. This is the DSS setting.

S/RF Meter

This meter swings proportionately to the RF
output (outgoing signal) while transmitting.
1
The S/RF-SWR-CAL button must be in the
S/RF mode.
36
continued
2 3
1.5
NB/ANL CAL
SWR
ANL
RX
S/RF
RF
3 5 7 9
1
SIG +30dB
VOL SQ RF GAIN
OFF MIN MAX
2 3
1.5
NB/ANL CAL
SWR
ANL
S/RF
RF
3 5 7 9
1
SIG +30dB
VOL SQ RF GAIN
OFF MIN MAX
External Speaker
The external speaker jack is used for remote receiver
monitoring.
SCAN CH 9/19
ANT
MEM WX ! EXT MIC EXT. PTT EXT.SP.
SWR
DYNAMIKE DELTA TUNE T BACK
CAL
Connect an external speaker to the external speaker
jack on the rear panel.
MIN OFF
External Push-to-Talk Jack
The external push-to-talk jack is used for remote
transmit function with optional PTT (see accessory page
47) and when the external microphone is connected.
ANT
EXT MIC EXT. PTT EXT.SP.
Connect an external push-to-talk device to the external
push-to-talk jack on the rear panel.
External Microphone Jack
TX
The external microphone jack is used to connect the
RX
supplied external microphone for phone use only.
When the external PTT (above) is connected, the
external microphone can be used for both CB and
MEM WX !
phone voice transmissions.
DYNAMIKE DELTA TUNE T BACK
ANT
EXT MIC EXT. PTT EXT.SP.
MIN
Connect the external microphone (included) to the
external microphone jack on the rear panel.
Operation
Note
The external speaker should
have 8-ohm impedance and
be rated to handle at least 4.0
+POWER–
watts. When an external speaker
is plugged in, the internal speaker
is automatically disconnected.
Note
Cobra external speakers are
rated at 10 watts.
+POWER–
SCAN CH 9/19
SWR
CAL
+POWER–
OFF
37