To Mount The Quickpanel View In A Panel - GE IC754VSB06MTD Hardware User's Manual

1

To Mount the QuickPanel View in a Panel

1. Verify that the gasket is properly seated in the bezel channel, then insert the
unit into the panel cutout.
2. Insert the hook of each mounting bracket in the housing openings as shown
below.
3. Firmly tighten the screws.
Note: The torque range for the mounting bracket screws is 2.6-4.4 inch/lbs
(0.3–0.5 Nm).
The mounting clamps hold the unit in place by tension. No drilling is required.
Do not damage the gasket attached to the back of the QuickPanel. This gasket
prevents shock hazards and damage caused by liquids accidentally entering
the unit after installation.
Also, limit the number of times you remove and reinstall the unit. Too many
installations may cause gasket "set" and degradation of the seal.
1-8 6" QuickPanel* ViewBasic, Monochrome, Round Bezel – September 2010 GFK-2327B