Cisco TelePresence MX800 Installation Manual page 10

Installation guide for Cisco TelePresence MX800 Dual - Floor stand
5
Read this before you mount the monitors
The monitors are heavy.
We recommend four people working
together to mount the monitors. Two
people should lift the monitor using the
handles as described below; the other
people must help stabilizing the monitor
and check that the monitor enters the
slots properly.
The screws with wing nut, which you
can see from the sides of the monitor,
must enter the center slot on each side
of the floor stand.
78-100574-02A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
Use lifting handles
To avoid trapping your fingers, use the lifting
handles at the bottom of the monitor.
Applies to systems that are secured to the
wall: To assure that the camera can move
freely, fasten two bumpons on the rear of
the top profile, close to the camera.
Left monitor, rear Right monitor, rear
Page 10