Panasonic KX-T30810 Installation Manual page 102

Extension does not operate.
Improper reset operation
Call is disconnected during
connection operation.
Noise in external paging
Volume distortion from
external music source
Speed dialing or One Touch
Dialing does not function.
A dial tone (short tone
continuously) was heard
and telephone line hung up
at once when accessing a
outside during the
speakerphone mode.
Bad connection between
system and extension
The system program switch
of the KX- is set to
T308I 0
PRO GRAM.
A telephone with an A -AI
relay is connected.
Bad extension
Instantaneous drop of DC
voltage from Central Office
(or host PBX) when in
operation of connection
between C. 0. and system.
Induced noise on the wire
between System and an
Amplifier.
I
Excessive input level from
external music source
Bad programming
The host PBX may cause
the line to hang up when the
KX- was connected
T308I 0
to it.
5-/
Take that extension and plug it into the same
extension port using a short telephone cord.
If telephone does not work, connection between the
system and the extension must be repaired.
Set to SET except when programming.
Use a wires cord.
2
Set the A -AI relay switch of the telephone to
O U T or OFF.
Take that extension and plug it into another
extension port that is working. If the telephone
does not work, replace the phone.
Press the Reset Button.
Program for a no CPC signal ( CPC means
Calling Party Control)
Set the calling party control signal to
"DISABLE".
Refer to page
2-28.
Use a shielded cable as a connection wire between
System and A mplifier.
A shorter shielded cable is recommended.
mcrease the Output level of the external music
source by using the Volume Control on the
music source.
Enter the line access code (9,
programming.
Use the handset instead of the speakerphone.
into
81, 82, 83)