Figure 2-10 Selecting The Network Dhcp Option; Figure 2-11 Camera Web Interface Showing The Mesh Network Button; Procedure 2-3 Configuring Camera's Host Ip Address To Dhcp From Wired Side Of Camera; Procedure - Motorola MOTOMESH 1.2 Setup And Configuration Manual

Chapter 2: Configuration
From within the IP Addressing tab, ensure that under the HOST heading, the Host Network DHCP
5
Enabled option is set to TRUE.
Note that the IP Addresses shown in the Host Fixed IP address are automatically generated at the initial
device setup time and do NOT reflect the TRUE Host IP Address shown. Please disregard. Follow the
instructions provided in the next step to find the true and correct HOST IP address.
Figure 2-10
End of Procedure.
6
Configuring the Camera's Host IP Address from the Wired
Side of the Camera to DHCP

Procedure 2-3

Configuring Camera's Host IP Address to DHCP from Wired Side of Camera
After connectivity is confirmed, set the options for the Wireless Card in one of two ways:
1
1.) From the camera home webpage, select the Setting button | Network tab | Wireless tab | Mesh
Network button. Selecting this button will provide access to the Mesh wireless card web interface.
Please note that this option will ONLY work when a MEA card is installed.
IMPORTANT NOTE: If you are presented with a Login dialog, use lowercase admin for both,
username and password.
Figure 2-11
6881011Y68-B October 2006
Selecting the Network DHCP Option
Camera Web Interface Showing the Mesh Network button
2-10